The three methods of rapid prototyping stripping
Time:2014-08-11 16:39 source:
Leecheer Author: Leecheer Click:
1.Manuel stripping
The operator use hand and some simple tools to strip the waste,supporting structure and
workpiece . This is one of the most common stripping method. For LOM molding products,
generally use this method to separate the grid waste and workpiece.
2.Chemical stripping
When a chemical solution can dissolve support structure without damage parts,can adopt
this method to separate the support structure and workpiece.For example,for the M061
molding products, can use the chemical solution to dissolve was,to separate the workpiece
(thermoplastics),support structure (wax), and basal (wax). This stripping method with high
efficiency and the workpiece surface is clean.
3.Heating stripping
When the support structure is was,whereas the molding material is melting higher than was
wax,the gas will melt the support structure and separate with workpiece.The efficiency of this
method is very high,can use hot water or proper hot steaming,the workpiece surface clean.
Keywords: The,three,methods,rapid,prototyping,stripping,